CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm
Posts: 1552
Not getting fire in a 1990 454SS chevy truck! Help!
Got my dads 1990 454SS with 57k miles on it after it sat in his garage for 13 years. Yea 13 years. Put new tires on it and dropped the gas tank and replaced the fuel sending unit and pump but haven't reinstalled it yet cause waiting on a replacement tank. So the sending unit and tank are off the truck. While i was waiting on that stuff via the mail i went ahead and did a fuel filter, oil, oil filter, trans filter, trans fluid, plugs, plug wires, distributor cap, rotor and coil. I didnt get any fire when i pulled #1 piston and turned truck over while watching plug against the block. So i replaced the module under the distributor and still no fire. I am not sure what else it could be. Also when i turn the key on the radio comes on but dosen't make any sound or it won't let me adjust the station/ volume. Could this be grounding issues or is my main computer fried? I'm lost. Needing help bad in SouthEast Texas.
CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm
Posts: 1552
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Anyone?
jldsc
MMT Pro Member
Joined: Sat Feb 16, 2013 12:03 pm
Posts: 461
Re: Not getting fire in a 1990 454SS chevy truck! Help!
verify 12 volts to the distributor first...check all fuses....i have this exact motor in a 1ton....some of these models have been known to be wiring nightmares....anywhere from fuse panels, ignition switches, steering columns, coils and distributors....chances are its minor, i havent had any issues with mine at all but have had friends that have.
Sent from an Apple Tree..
CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm
Posts: 1552
Re: Not getting fire in a 1990 454SS chevy truck! Help!
i checked to the coil and i have 12 volts but should i have 12 volts at the distribitor or more cause its fed through the coil already?
Swampnuts
MMT 1000 Club
Joined: Wed Dec 12, 2012 3:12 pm
Posts: 1504
Location: St.Amant,LA
Re: Not getting fire in a 1990 454SS chevy truck! Help!
You should have 12volts at the dist.
You might have a bad pick up wire on the distributor.
_________________
16X48 WELDBILT -25GTR EFI-sold
18x48 GTB - 35 GTR
Crown royal pro-staff
CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm
Posts: 1552
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Nothing? Got 12 volts at the distributor.
BayouBuster
MMT 1000 Club
Joined: Sat Jun 25, 2011 8:33 am
Posts: 1352
Location: Genoa AR
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Probably a dumb question but did you make sure the rotor button is spinning when you turn the engine over? If you have 12 volts at the distributor but no fire it's either, module or distributor itself.
BayouBuster
MMT 1000 Club
Joined: Sat Jun 25, 2011 8:33 am
Posts: 1352
Location: Genoa AR
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Another thing, have someone turn it over while you check the voltage at the distributor, sometimes the ignition switch can go bad and you'll lose voltage when you turn it over.
netman
MMT 1000 Club
Joined: Wed Jan 14, 2009 3:48 pm
Posts: 2363
Location: Chandler,Indiana
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Pull a spark plug and hook it back to the spark plug wire and ground it while turning the engine over to see if there is any fire. If not its ignition, if so its fuel. I'm not a mechanic however thats how I would do it.
_________________
I got a shotgun,rifle and a Go Devil Surface Drive a country boy can survive.
35+hp GDSD engine mods by George Merta
18x48 GDSD boat
jldsc
MMT Pro Member
Joined: Sat Feb 16, 2013 12:03 pm
Posts: 461
Re: Not getting fire in a 1990 454SS chevy truck! Help!
DUCK HEARSE
MMT 1000 Club
Joined: Fri Apr 06, 2012 8:48 am
Posts: 3161
Location: Alabama
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Does that truck have anti theft if so you might have to reset it. Commen with chevys
_________________
Twenty years from now you will be more disappointed by the things that you didn't do than by the ones you did do. So throw off the bowlines. Sail away from the safe harbor. Catch the trade winds in your sails. Explore. Dream. Discover.
- Mark Twain
CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm
Posts: 1552
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Ok no spark at distributor cap. rotor turns, one more question what in the steering column goes bad?
jldsc
MMT Pro Member
Joined: Sat Feb 16, 2013 12:03 pm
Posts: 461
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Duck Hearse, that model should be pre-anti theft..believe those started in about 96 with the vortec systems. Did you verify that 12v is constant in the start position while turning it over? There is a module on the bottom side of the steering column right around where the 2 bolts to mount it to the dash. The ignition switch pushes a rod down to this module, should be white in color, and makes the contacts and sends the current to need accy...i.e, starter-distributor...
Sent from an Apple Tree..
jldsc
MMT Pro Member
Joined: Sat Feb 16, 2013 12:03 pm
Posts: 461
Re: Not getting fire in a 1990 454SS chevy truck! Help!
It should show it in a repair manual that you can get at your local Autozone, Oreilly's...
Sent from an Apple Tree..
jldsc
MMT Pro Member
Joined: Sat Feb 16, 2013 12:03 pm
Posts: 461
Re: Not getting fire in a 1990 454SS chevy truck! Help!
one other simple thing that can get overlooked...checked all fuses???
Sent from an Apple Tree..
CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm
Posts: 1552
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Not sitting in front of the truck at this moment but when i do i'll check all what ya said. thanks!
take'emgator
MMT Super Elite Member
Joined: Mon Oct 19, 2009 6:38 pm
Posts: 10201
Location: SETX
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Brandon you sure you have the wires right from the distributor to the correct cylinder/plug?
CLICKSTER
MMT 1000 Club
Joined: Sat Feb 12, 2011 4:08 pm
Posts: 1552
Re: Not getting fire in a 1990 454SS chevy truck! Help!
Really man? yes i do and it will still show fire. the pickup coil is bad. i pulled distributor replaced and going to restab the distributor and time engine tonight or tomorrow.
take'emgator
MMT Super Elite Member
Joined: Mon Oct 19, 2009 6:38 pm
Posts: 10201
Location: SETX
Re: Not getting fire in a 1990 454SS chevy truck! Help!
lol man you never know lol