How To Reset Edenpure Heater (2024)

FAQs

How To Reset Edenpure Heater? ›

The easiest way to fix most EdenPure heater problems is to turn off the unit, unplug it from the wall for 10 minutes, and then start it up again. This will ensure that there is no lingering power in any of the circuits and allow the unit to do a full reset.

First, you should unplug the heater's power cord from the power outlet for at least 30 minutes. This will reset the internal electronics of the EdenPURE 1000 heater. Finally, plug the power cord back in to the power outlet and then, attempt to operate the heater again.

The heater will not operate when the temperature is too high. Test the heater in a room that is below 75 degrees Fahrenheit. Bring the heater inside to warm up for at least one hour before operating if it has been stored in a freezing or near freezing environment. Make sure the filter is clean.

EdenPURE heaters are equipped with a thermal fuse that automatically shuts off the power if it detects abnormally high temperatures.

First, turn off the power supply to the furnace by turning off the breaker in the circuit box. Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor.

Turn your thermostat “off”, then flip the related circuit breaker “off”. Wait 30 seconds, then turn the breaker back “on,” then the thermostat. Set the thermostat to hot or cold, whichever you prefer, and your desired temperature. This should effectively reset it.

For 20+ years, AirNmore® has been successfully repairing and servicing a variety of infrared portable heaters, including the most popular EdenPURE heaters, for thousands of consumers throughout the United States.

I operated my Edenpure heater 24/7 for 10 years without a problem. Both heaters have the same technology so I feel comfortable operating the Mr Heater 24/7.

Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended. 3. Always unplug heater when not in use.

Why is my EdenPURE blowing cold air? ›

Why does my EdenPURE Gen2 automatically shut down or blow cold air? First, check your filter. The unit is likely shutting down or blowing cold air due to a dirty filter. The heater filter must be kept clean in order for your Gen2 to operate correctly.

Somewhere on your electric water heater, you'll find a reset button. It's usually red and often located near the thermostat. It may also be hidden behind a removable metal panel on the unit—and then behind some insulation. Once you find the button, push and release it.

Make sure the power outlet you are attempting to plug your EdenPURE 1000 heater in to is truly supplying power. Plug in another appliance or fixture such as a lamp to see if the power outlet works. Next, make sure the master power switch/button is set to the “ON” position.

Why is my EdenPURE 1000 heater automatically turning off or blowing cold air? A dirty filter will result in the unit to automatically shut down, blow cold air or not function at all. For filter cleaning instructions, please refer to the EdenPURE 1000 product manual. It is very important to keep heater filter clean.

Find the Reset Button: Locate the reset button. It's typically found inside the blower compartment on the side of the blower motor. Press the Reset Button: If the reset button pops up, press it down to reset the furnace.

Why is my EdenPURE 1000 heater automatically turning off or blowing cold air? A dirty filter will result in the unit to automatically shut down, blow cold air or not function at all. For filter cleaning instructions, please refer to the EdenPURE 1000 product manual. It is very important to keep heater filter clean.